roller shutter door roll forming machine cold roll forming machine

Roll material:45# high grade steel

Roll stations:18 rows
Shaft material:45# high grade steel
Cutting system:automatic hydyaulic cutting
Kind of drive:chain system drive
Frame material:300 H-high grade steel
Cutting blade material:Cr 12 high grade steel

Molding
Unwinding-guiding-forming-punching-sizing and cutting

Equipment composition
The equipment consists of a discharge machine, a forming host, a correction device, a punching frame, a punching die, a cut-to-length part, and an electrical control part.

Equipment performance
1. Rolling capacity of the unit: width≤300mm,
2. Sheet thickness 0.8-1.2mm
3. Total installed capacity: about 20kw
4. Production speed: 0-10m/min

The equipment produced by our company has the following advantages:
1. The equipment is controlled by PLC, and multiple safety protections are set during normal production.
2. The bed is welded steel plate. And it is tempered to eliminate internal stress and avoid deformation of the fuselage.
3. The forming frame is a cast iron structure and has been tempered. High strength and long service life.
4. The material of the roller shaft is 40Cr, and the hardness is HB280 after quenching and tempering.
5. The material of the forming mold is GCr15, quenched, and hardness: HRC56-62℃.
6. The transmission structure is gear box transmission. Each forming frame has a gear box, which can ensure the equipment over time, high intensity operation, and long service life.